Does Wolf Pack Masonry work in Dana Point?

Yes — Dana Point is part of our main service area in South Orange County. Text (909) 243-0738 or start at wolfpackmasonry.net/start; estimates are free.

Dana Point · cost guide

Pavers & porcelain cost in Dana Point (2026)

In Dana Point, Pavers & porcelain work from Wolf Pack Masonry starts around $11 per sq ft (our October 2026 price list), depending on size and finish.

Starting prices, not a quote — the final price comes after a free site walk and a written scope.

Ballpark it: Patio & deck estimator Text José your project

What it costs — line by line

What it costs — line by line
Item	From
Pavers — prep & install on sand base	$11 / sq ft
Paver steppers — install	$18 / sq ft
Porcelain pavers or steppers — install	$11 / sq ft
Porcelain sub-base concrete — flat decks	$11 / sq ft
Porcelain sub-base concrete — steppers/ribbons	$18 / sq ft
Paver steps	$18 / linear foot

Homeowner "from" prices, October 2026. Tile, stone, pavers and pre-cast are your pick (by owner or an allowance).

Published cost guides for comparison (not our price): $21–$36 / sq ft · San Diego, pavers installed WITH material (our price is install only — pavers by owner) · Install It Direct — paver cost (2026-10-23)

Permits in Dana Point

No building permit for a driveway not more than 30 in above grade, but the driveway approach, curb or sidewalk in the right-of-way needs an encroachment permit.

DPMC 8.02 (CBC §105.2 item 6); Encroachment Permits; DPMC Ch. 9.35 · Sources (2026-10-23):

Check your exact project →

The Coastal Overlay takes precedence over other zoning, and a CDP is required for all development unless exempted — even when no other approval is needed. Improvements to an existing home are exempt except on a beach, within 50 ft of a bluff edge, or (between the sea and first public road) new detached structures. Capistrano Beach is part of Dana Point.

No residential design-review rules for walls or hardscape were found — ask Planning, (949) 248-3568.

Near the ocean

Salt spray in the air drops sharply between about 300 and 3,000 ft from the shoreline (Simpson Strong-Tie).
Suppliers define a "marine environment" anywhere from 1,000 ft to one mile from salt water — check your product's warranty.
Type 316 stainless resists corrosion better than 304 in coastal, high-chloride air; Type 410 is for low-corrosion settings only.

Check your address →

Dana Point HOAs with public guidelines

Niguel Shores Community Association (NSCA) · 45-day review

Make an HOA submittal packet →

Confirm with the city or your HOA before you build — rules change.

Pavers & porcelain in Dana Point: quick answers

How much does a Pavers & porcelain cost in Dana Point?: In Dana Point, Pavers & porcelain work from Wolf Pack Masonry starts around $11 per sq ft (our October 2026 price list), depending on size and finish. Starting prices, not a quote — the final price comes after a free site walk and a written scope.
Do I need a permit for a Pavers & porcelain in Dana Point?: No building permit for a driveway not more than 30 in above grade, but the driveway approach, curb or sidewalk in the right-of-way needs an encroachment permit. Confirm with the city or your HOA before you build — rules change.
Does Wolf Pack Masonry work in Dana Point?: Yes — Dana Point is part of our main service area in South Orange County. Text (909) 243-0738 or start at wolfpackmasonry.net/start; estimates are free.

Published by Wolf Pack Masonry · CSLB Lic. #1100601 (C-29). Prices from our live price list; permit facts cited to each city's published code.

Free estimate

Tell us what you're building.

Send a few photos and a rough idea. We'll set up a site walk, measure it, and get you a written scope with a price — no charge, no pressure.

Get a free estimate Call (909) 243-0738

Pool builder or GC? Send the plan set and we'll turn a scope sheet around.